Preparation
◆Pry Tool
◆Electric Drill
◆ Scissors
Remove the Trim Panel
1. Use a pry tool to remove the passenger side tailgate trim.
2. Remove the white clip from the decorative panel and install it on the passenger side pillar light.
3. Use an electric drill to make a small hole at the pillar light harness,and pass the harness of the pillar light through the small hole. (Note: No hole needs to bed rilled on the driver's side,the harness can be passed directly.)
Connect the New Brake Light
4.Install the pillar lights in the original car hole position.
5.The wiring harness of the pillar lamp passes through the small hole and is routed along the lining above the tail-gate toward the driver's side.
6.The wiring harness for the pillar lights is routed along the lining under the tail-gate toward the passenger side and then along the direction of the tail lamp.
7.On the inside of the trunk,open the cover behind the taillight.
8.Take out the adapter harness and connect the adapter harness to the pillar light harness.
9.Unplug the taillight plug and connect one end of the taillight plug to the adapter harness.
10.Connect the other end of the two.
11.Put the wiring harness plug behind the taillight and close the cover.
12.Repeat the above steps to install the pillar light on the driver's side.The installation is complete.
