Tools and Materials Needed
●10mm Socket
●Pry Bar
Step 1: Remove your original trail sight
Use a 10mm socket to remove the bolt
Step 2: Remove the seal of the original
Use the tool to pry off the seal of the original
Step 3: Remove the seal completely and attach it to the new trail sight lights
Step 4: Replace the new trail sight marker lights back to the Bronco
Use the provided bolt to install and tighten it back into place
Step 5: Remove the flender flare for easier access to the wheel well
Push the pin right here that was removed, plus one bolt that you can remove here, and then peel back the fender flare so you can access the headlight
Step 6: Unplug the headlight harness
Step 7: Pull through the connector from the trial site light and clip it into the included harness
Step 8: Plug the headlight connector that you removed into the harness provided
